spec no: dsab2938 rev no: v.5 date:jun / 15 / 2005 page: 1 of 5 approved: j. lu checked: joe lee drawn: w.j.zhu erp:1351000027 surface mount display features 0.3 inch digit height. low current operation. excellent character appearance. i.c. compatible. mechanically rugged. gray face,white segment. package : 1100pcs / reel. package dimensions & internal circuit diagram notes: 1. all dimensions are in millimeters (inches), tolerance is 0 .25(0.01")unless otherwise noted. 2. specifications are subject to change without notice. description the hyper red source color devices are made with dh ingaalp on gaas substrate light emitting diode. apsa03 - 41surkwa hyper red
spec no: dsab2938 rev no: v.5 date:jun / 15 / 2005 page: 2 of 5 approved: j. lu checked: joe lee drawn: w.j.zhu erp:1351000027 selection guid e part no. dice lens type iv (ucd) @ 10ma min. typ. apsa03 - 41surkwa hyper red (ingaalp) white diffused 3000 15257 common anode, rt. hand decimal. description electrical / optical characteristics at t a =25 c absolute maximum ratings at t a =25 c note: 1. 1/10 duty cycle, 0.1ms pulse width. symbol parameter device typ. max. test conditions units peak peak wavelength hyper red 650 nm i f =20ma d dominant wavelength hyper red 635 nm i f =20ma ? 1/2 spectral line half - width hyper red 28 nm i f =20ma c capacitance hyper red 35 pf v f =0v;f=1mhz v f forward voltage hyper red 1.95 2.5 v i f =20ma i r reverse current hyper red 10 ua v r = 5v parameter hyper red units power dissipation 170 mw dc forward current 30 ma peak forward current [1] 185 ma reverse voltage 5 v operating/storage temperature - 40c to +85c
spec no: dsab2938 rev no: v.5 date:jun / 15 / 2005 page: 3 of 5 approved: j. lu checked: joe lee drawn: w.j.zhu erp:1351000027 hyper red apsa03 - 41surkwa
spec no: dsab2938 rev no: v.5 date:jun / 15 / 2005 page: 4 of 5 approved: j. lu checked: joe lee drawn: w.j.zhu erp:1351000027 recommended soldering pattern (units : mm ) tape specifications (units : mm ) apsa03 - 41surkwa smt reflow soldering instruction s number of reflow process shall be 2 times or less and cooling process to normal temperature is required between first and second soldering process. reel dimension
spec no: dsab2938 rev no: v.5 date:jun / 15 / 2005 page: 5 of 5 approved: j. lu checked: joe lee drawn: w.j.zhu erp:1351000027 packing & label specifications apsa03 - 41surkwa remarks: if special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. wavelength: +/ - 1nm 2. luminous intensity: +/ - 15% 3. forward voltage: +/ - 0.1v note: accuracy may depend on the sorting parameters.
|
